VAGCOM

hey there has anyone got vagcom i know there is a program that you can set on your remote locking to roll the windows up when you lock the car and down if you hold your finger on the unlock button.?
is there anyone here that can do that i dont have a clue about that sort of stuff.??


Thanks

Lee.

I think Calimori might have one!

ok how do i get in contact.?

Thanks.

hes on here, i have it but im very new with it, and my laptop is currently in the states with a bunch of our jetskis lol!

Calimori or Sparkie, give either of them a pm!

You have a PM. If you can research and post the code on here then I will check we can do it on your car.

hiya mate here it is.

Now with out spending lots of money on alientech or autowindows you can now open and close your windows with your remote keyfob...

Just need a laptop with serial connection, or a long ass serial extension cable from your desktop, a copy of VDc_pro which i will provide a link to if requested, and a serial version of the vag-com cable (i think 2002 and newer leons require the dual kkl cable £14 off ebay)...

And use the following instructions:

You can't do this from any windows version (Dos only!), with any USB interface or with VAG-COM or a VW 1551 tester.

Use the following procedure to reprogram the module

1. start vds from boot disk + turn ignition on(not start car)
2. connect to central convenience (46)
3. start login procedure (11)
4. use the code 19283
5. read serial eeprom (26)

Check memory locations:
04361
04362
04363

They should show up with 2 lines of values just look at the 1st value on the dec04361 line it should read 10

for all 3 memory locations the 1st value should be 10

6. write serial eeprom (27)

you then type in the 3 memory address again:
04361
04362
04363

and put the new value as 2

You can now read serial eeprom (26) again to check that the 1st value in the memory address's has been changed to 2

7. end output (06)

close and exit program disconnect from car.

Now exit your car and lock it. When you now open your car with the keyfob and hold the button the windows should start to roll down and stop when you lift your finger. Also when you lock the car now and hold the button down the windows will go up(close) until you lift your finger off the button...

And hey presto you got remote windows!!!

http://www.seatcupra.net/forums/showthread.php?t=93787&highlight=vag+windows&page=4

thats the link to the forum.



Well let me know what you think.?

OK, we don't lose anything for trying and those code areas make sense.

I have the full version of VAG-com with a USB cable and this recommends doing it with the older serial kit which sounds a bit rubbish tbh.
If the puter knows about it, we can change it.

Hopefully see you are the next Nomads meet then .

i'll be there mate.!!

i found this. =)

http://www.seatcupra.net/index.php?option=com_content&task=view&id=553&Itemid=6

Print that out and we can use it tonight...

my printer is foooooked. =( do'h

In absence of a copy supplied by your good self, I got to reading it so I could understand what we were trying to do.

I am now less use this is supported by VAC-com or your car but we can still take a look.